Everyday care

To ensure that your IMPRESSA or ENA produces top-quality coffee and functions correctly, the machine should be cleaned and maintained on a daily basis. You should proceed as follows:

• Empty coffee grounds container and drip tray every day and rinse with hot water.
• Clean and de-scale the machine or change the CLARIS plus filter cartridge when instructed to do so in the display.
• Wipe the machine surface with a damp cloth or wipe the coloured front panels with the JURA caring cloth.

Integrated cleaning programs

The integrated cleaning program for your IMPRESSA X7 can be started at any time in either of two ways:

• With display prompt:
  If SELECT PRODUCT / CLEAN MACHINE appears in the display, open the cover of the programming keys at the top right and hold the Cleaning button down until SELECT CLEANING - + appears.
• Without display prompt:
  If SELECT PRODUCT appears in the display, open the cover of the programming keys at the top right and hold the Cleaning button down until SELECT CLEANING - + appears.

Now select the required cleaning program using the – or + button. To start the selected program, press the Rinse button again.

• Note: The following cleaning programs can be selected:

CAPPUCCINO CLEANING / COFFEE CLEANING / ENTIRE CLEANING

• Note: A display prompt is only given for COFFEE CLEANING. It is up to you to carry out Cappuccino and Entire cleaning.
• Tip: If the machine is used to make milk products, we recommend that Cappuccino cleaning is carried out every day.

Note: The factory setting causes a rinse to be automatically initiated 10 minutes after the milk has been dispensed. However, this time can be modified by JURA Gastro service partners. The rinse operation is announced by an auditory signal.

Integrated descaling program

The descaling program for your IMPRESSA X7 can be started at any time with or without a display prompt.

• With display prompt:
  If SELECT PRODUCT / MACHINE CALCIFIED appears in the display, switch your machine off. Open the cover of the programming keys at the top right and hold the Descaling button down until an auditory signal is heard. If only two short auditory signals are heard, the machine is still switched on.
  
  
• Without display prompt:
  If SELECT PRODUCT appears in the display, switch your machine off. Open the cover of the programming keys at the top right and hold the Descaling button down until an auditory signal is heard.
  If only two short auditory signals are heard, the machine has been programmed for filter operation or it is still on.

• Note: If MACHINE CALCIFIED is displayed for an extended period, the descaling program was started with too much liquid or the water was replenished before the tank was empty.
  
  
• Tip: Start the descaling program again with 0.7 litres of water. During the program, the water tank is completely emptied. Please do not refill with water until you are prompted to do so in the display.

CLARIS filter change

The first installation of the CLARIS filter cartridge must be carried out by the service engineer. Please contact your JURA Gastro service partner.

The filter change program for your IMPRESSA X7 can be started at any time in either of two ways:

• With display prompt:
  If CHANGE WATER FILTER appears in the display, switch your IMPRESSA X7 off. Now press the Rinse, Hot Water and Steam buttons simultaneously and hold them down until “OK” appears on the display.
  
  
• Without display prompt:
  If SELECT PRODUCT appears in the display, switch your IMPRESSA X7 off. Now press the Rinse, Hot Water and Steam buttons simultaneously and hold them down until “OK” appears on the display.

Coffee taste and temperature

Coffee taste:

Are you dissatisfied with the coffee taste? If the coffee tastes unpleasant, this could be due to any of the following reasons:

• The degree of grinding has not been set to your taste. Please note that the degree of grinding can be individually chosen for every drink dispensed (see Instruction Manual, section 15.1).
• Note: Your IMPRESSA X7 is fitted with two grinders, which can be coordinated as follows: left grinder 0%, right grinder 100 % / left grinder 25%, right grinder 75% / left grinder 50%, right grinder 50% / left grinder 75%, right grinder 25% / left grinder 100%, right grinder 0%.
• Your coffee beans are "sour". Empty the bean container and fill it with fresh beans.

Coffee temperature:

Is your coffee not hot enough? If the coffee is not hot enough, this could be due to any of the following reasons:

• The coffee temperature was not set to HIGH. Please note that the temperature can be individually programmed for each of the draw-off buttons ("NORMAL" or "HIGH").
• If you are not using a CLARIS filter cartridge, your machine may be furred. Check the water hardness, programme this correctly and de-scale the machine.
• Tip: Heat up your cup in advance!

Milk foam

If the milk will no longer go frothy, we recommend that you carry out Cappuccino cleaning.

• Tip: If the machine is used to make milk products, we recommend that Cappuccino cleaning is carried out every day.
• Tip: For cleaning purposes use the special Cappuccino cleaner.
• Note: The fat content of the milk has no effect on the froth. Even skimmed milk can be used.
• Tip: Calcium deposits can have an adverse effect on dispensing steam. If you are not using a CLARIS filter cartridge, the descaling program can be run at the appropriate time.

Display and text messages

What should I do if one of the following messages appears on the display of the IMPRESSA X7?

MACHINE CALCIFIED: the machine must be descaled.

• Run the descaling program in accordance with chapter 20 of the Instruction Manual.

MACHINE CALCIFIED appears for an extended period.

• The descaling program was started with too much liquid or the machine was replenished with fresh water too early. During the descaling program, the water tank must be completely emptied.
• Tip: Run the descaling program again with 0.7 litres of water.

COFFEE READY is displayed, but the coffee tastes unpleasant.

• The degree of grinding has not been set to your taste. Please note that the degree of grinding can be individually chosen for every drink dispensed (see Instruction Manual, section 15.1).

If the FILL COFFEE BEANS message does not go out, this could be due to one of the following reasons:

• The display only goes out after a drink has been dispensed.
• The sliders (locking device for the been container) were closed (see Instruction Manual, Fig. 6).
• There may be a foreign object in the grinder (see Instruction Manual, section 16.8 “Stone removal”).

MALFUNCTION

• This message could have a number of causes. Please contact your stockist.

Caramelised coffee beans

To ensure that your machine provides satisfaction for a long time and to avoid repairs, please note that the grinder on your JURA coffee machine is not suitable for coffee beans that have been treated with additives (e. g. sugar) during or after roasting.

Use of such coffee mixtures can result in damage to the grinder. Any repair costs incurred as a result are not covered by the warranty provisions.